Thread: Capehart 661-P
View Single Post
  #47  
Old 06-01-2011, 10:46 AM
John Folsom's Avatar
John Folsom John Folsom is offline
VideoKarma Member
 
Join Date: May 2004
Location: Melbourne Florida
Posts: 932
The silver filled epoxy worked well on the K, G1, G2 and convergence leads on a 15GP22. I obtained this tube with a smashed base and the 4 wires broken off flush with the glass. I put a little collar around each broken wire, and filled the collar with epoxy and inserted a length of very fine flexible wire into the top of the collar and let it cure in place.

Then all the CRT leads had long pigtails attached and threaded into the base pins and the base slid back into place, soldered, and the excess pigtails cut off.

The 15GP22 tested good after the operation was complete.

Sadly, several years later, when it came time to use the repaired 15GP22 in a set, it had the dreaded purple glow.

I speculate that the CRT was damaged when the base was broken, but it could also have been a spontaneous leak at the glass-to-metal joins at the ultor, or the ultor seam weld. If our first shipment of 15Gs to RACS is successful, this tube will be cut open and leak checked.

The only down side to the silver filled epoxy approach is that the epoxy is quite expensive, and might not be justified for a "common" tube like a 10BP4.

Sorry, did not intend to hijack the thread....
Attached Images
File Type: jpg PREP_1.JPG (108.9 KB, 66 views)
File Type: jpg REPAIR_1.JPG (8.7 KB, 64 views)
__________________
John Folsom
Reply With Quote