View Single Post
  #3  
Old 05-17-2011, 08:24 PM
vts1134's Avatar
vts1134 vts1134 is offline
Looking For Time
 
Join Date: Apr 2011
Location: Pittsburgh, PA
Posts: 1,534
Got the new transformer in the set and it gives deflection but not a full picture. It did bring the horizontal picture back to the center again. Even though it was not a full height picture it did for the first time look "correct." It might be because I could see scan lines for the first time, or because the picture was horizontally aligned, or it could just all be in my head. I did try adjusting the vertical hold control, the vertical linearity control, and the vertical size control, all to no avail. The transformer I used was a Stancor model a-8122. The turn ratio was 1:4.2. The primary and secondary impedance was a bit different on the replacement than the schematics showed on the original. The original was 160 and 1,300 and the replacement was 170 and 940. Could the transformer still be the problem or is it time to look elsewhere?
Reply With Quote