View Single Post
  #2  
Old 04-22-2011, 09:15 PM
droptop's Avatar
droptop droptop is offline
Behind in Time
 
Join Date: Jul 2008
Location: Ooltewah, TN
Posts: 78
Bob,
I hope this sheds some light on your switch dilemma. This is a photo of the switch originally used in your set. It has a notch in the handle for actuation by the wire link. The collar on this one is ¼ inch long. If you can find a short collar switch it’s easy to file the notch in to the handle and the short collar will make for easy operation by the wire link. The long collar shaft takes a lot more force to flip.

That is a great set. I have one I’ve yet to restore but there have been several on my bench over the years. Sparton was good at coming up with their own tubes hoping to corner the renewal market. National Union is about the only maker I’ve found that supplied replacements for some Sparton numbers. The 183 tubes are non existent as you’ve discovered. Luckily they were in my set when I bought it about 6 years ago. The first one I restored was back in the early ‘80s and they were missing. I found a long ago published hint in a radio magazine concerning availability of these tubes that was written by a service man who could not find them- even then. His remedy was to wire the filaments in series and use a pair of 45 tubes. It worked quite well and the power transformer didn’t seem to mind at all. 45’s are pricey but also easier to find. 71A tubes have a maximum of 180 plate volts. Check the voltage on your set to be sure it isn’t pumping out around 250 which is the maximum for the 183’s and maybe the 45’s as well. If you don’t play the set very much it may be a non issue in the long run. Most Sparton sets of this era tend to run tubes at or near maximum operating voltages- another stab at selling replacements, no doubt.

Best regards,
Rick
Attached Images
File Type: jpg sparton switch.jpg (29.9 KB, 18 views)
Reply With Quote