View Single Post
  #11  
Old 03-22-2011, 03:59 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
I know this has come up before but from what I gather there are 3 types of implosion protection

1) separate safety glass (I asssume the glass is true laminated safety glass not just a reg pane of glass. this just contains any of the damage from the front of the crt


2) bonded glass face plate (essentially safety glass made from the CRT face, plastic,second layer of glass), that is a tough plastic film that contaings the shards of broken glass in case of breakage, this would be the same stuff that is causing the cat to form as it breaks down). This does notthing to prevent an implosion, but if one were to occur then the screen would do like a patio door glass made the same way, lots of small broken pieces all stuck to the plastic, and not stuck to your body.


3) Tension ring, from what I have read this keeps the perimeter of a tube from expanding, which is the failure mode as a tube attempts to implode. The reason for tenison is to prestress the band so it can not expand, thereby keeping the perimeter size from expanding.

It would seem the bonded glass makes no real attempt to prevent the actual implosion, but is rather an attempt to containg the glass. Perhaps the mounting brackets/ring peform the function of perimeter containment on those.

again maybe it was determined that if the rim was contained by the mouniing hardware the implosion protection was sufficent to no longer warrent the need for the shatter protection afforded by the plastic lamination. By incorporating the tension band as a perm fixture to the tube the protection would stay with the CRT even when it was not installed in the set (where before the band was part of the TV mounting hardware).


I am not sure of all the above, just what I have been able to get after a lot of searching. there was talk of just the above over on a UK site as well.
Reply With Quote