View Single Post
  #4  
Old 03-21-2011, 08:33 PM
JCFitz JCFitz is offline
VideoKarma Member
 
Join Date: Sep 2005
Location: Willards,MD
Posts: 411
Well it did it again a few times in the first half hour I had it on tonight and then stopped again.I had it on a letterbox format tv show and it actually increases in height slightly and goes back not decreases in height.

At first I thought maybe the height control itself was doing it but tapping on it or the linearity control had no effect. Maybe once did I see it jump when I tapped the vertical output tube but it could have been a coincidence.Couldn't get it to repeat.It did it a couple of times afterward and then stopped again.

From what I've seen once the set gets good and hot it stops doing it.It's been recapped of course but not the micas. There is one mica in the vertical where the sync enters the oscillator.Wonder if that might have something to do with it?

On the ticking problem I think it might be the hv socket cap breaking down somehow or the hv rectifier filament wire. Can't see any corona from the connections. I have one of those mechanics mirrors with the handle on it and held it in back of the upright chassis where the connections were and turned off the lights and couldn't see anything.
Reply With Quote