|
Ditto what Andy said above - green, red and orange 'lytics were famously the troublemakers in Toshiba and Sears sets. Make sure you get the 4.7uF at 160V and the little 2.2uF caps (C30X series caps, 50V IIRC) in the vertical, and if used, scrape off any yellow glue from the bottom of the board in the sweep area and CRT neck board. Other than that, mostly we saw bad solder connections on the flyback and around the power resistors.
That yellow glue was insidious.
Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"
When fuses go to work, they quit!
|