View Single Post
  #3  
Old 03-12-2011, 07:52 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by Eric H View Post
I decided to see if the 15" set would run using the drop from the transformer, sure enough it does, CRT is very strong on this one too, everything seemed to work but I got no sound from the speaker except possibly a slight hum.
It actually was the Isolation Transformer that was humming and it got loud, resonating off the bed of my truck, struggling with the load the set was putting on it.

The set seemed to be working fine still but it was clearly drawing too much current.

So what do you guys think, bad caps loading it down or bad regulator?
I guess I need to take the back off and see if anything gets hot, I don't want to blow the HOT though.
The regulator transistors in those Sonys were a common problem - they'd short E-C, or go leaky B-C, giving you excess B+. Part number is MN8303 (preferred) or use a 2SC2581, and an NTE36 will do as well. Don't over torque the mounting screw when replacing them - the heat makes them expand somewhat and you'll be right back to square one if you torque too much. The driver transistor that feeds the regulator should be replaced as well when you replace the regulator - it'll check just fine, but go open on you, necessitating a call back. Other than that, most other problems were either audio related or bad remote functions - the IR Amplifier chip would short, pulling down the 12V line. OH - Get rid of any yellow glue in the regulator area too - it degrades with heat, turns brown, and becomes quite conductive. They are really good sets - I had a 17" one (KV-1746R) in my den for a few years.

Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!

Last edited by Findm-Keepm; 03-12-2011 at 07:52 PM. Reason: plural...
Reply With Quote