Thread: Rca?
View Single Post
  #14  
Old 03-09-2011, 10:41 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
the board I pulled is in the 4th pic on my chassis shot, 3rd board on the right, just above the horz adj (long red pot shaft).

a couple other thins, the horz hold is super critical, it will flop one way then the other. You can get a stable lock, but it only has a couple degrees of rotation at best to hit the right spot (which is in the aprox middle).

The vert lock is strong so I doubt its a problem with the sync sepearater, I am thinking the AFC circuit in the horz. Maybe some drifted resistors or dual diode (I assume this is how its horz AFC works if its like tube sets), perhaps even a weak cap in the feed back pulse, just guessing. I am going to let it run for a while and see how it goes.

This thing would be a "green" tv by todays standards, its barely pulling 1 amp, my tube sets are amp hogs by comparison.
Reply With Quote