|
Phonevision was an idea that Zenith had, which would have been sort of like cable TV, or maybe even the internet! It never took off, though.
The crt base shouldn't be loose, but many/most of them are. You can use some glue or tape to hold it tight-there are some suggestions on this site somewhere as to what works best. I haven't tried to fix one with glue for a long time. Just be careful that you don't wiggle it around so much. The wires coming out of the neck tend to be brittle and can snap off even with the glass-not good!
The museum is well worth the visit, and there are several VK members scattered around the state. Maybe one could give you a hand with a crt test?
Am I correct that the crt is strapped to the chassis on this model? I will usually place them on their side gingerly, maybe with an old towel under the crt. Make sure the crt is strapped down tight so it doesn't shift when you move the chassis over. On some I have used a pair of clamps to hold the chassis down to the workbench (in my case, and old desk) while working on it. The crt is the main thing you have to keep an eye on-I don't think you will hurt anything else.
__________________
Bryan
Last edited by bgadow; 03-02-2011 at 10:30 PM.
Reason: clarification
|