View Single Post
  #5  
Old 03-01-2011, 10:50 PM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
Nice set! I love Portholes.

That should be a 12UP4 tube, this is a metal/glass construction tube, they tend to be bad more often than all glass tubes because of leakage however the smaller ones seem to have a better track record than the larger sizes. (Search 19AP4)

You can check to see if it's still under vacuum by removing it from the set and looking for the Getter Flash on the neck of the tube, shiny and dark indicates it's under vacuum, white and powdery means it's gone to air.

I notice some discoloration on the screen in the upper right side, I'm presuming it's just dirt but I'd inspect it closely.

Handle the tube very carefully, be very careful not to bump it on the rim around the screen as that is it's weakest point for cracking.

Also note that when the set is operating the entire bell of the CRT has 10-12 thousand volts on it.

I'd also take a good look at the Flyback transformer, they are a known trouble spot on these Zeniths, just visually inspect it and see if it looks burnt.
Reply With Quote
Audiokarma