|
According to the schematic there should be around 45 volts going into the detector audio transformer primary so check your wiring; should not be getting 124V at the detector plate. Check between plate terminal and B-.
Try bridging the grid leak with a high value resistor, anything from 2 meg to 5 meg should be OK. Just tack it in temporarily for now. Old grid leak may be open.
Did you check all of the RF coils for continuity with the ohmmeter?
Does the "shunt" look like a wire wound resistor with slider? Don't see anything like that on the diagram. Where is it exactly per the schematic?
__________________
Reece
Perfection is hard to reach with a screwdriver.
|