|
CTC203/ATC113 are good stuff, but there are many exceptions, I worked on them for a living and know them rather well.
There were 2 early and late CTC203 chassis systems. The early ones is MUCH better as you do not have to worry about unreliable gemstar module and all you do is unhook the one ribbon connector and you are done since board already have micro controller on the mainboard. The late CTC203 and all ATC113 used gemstar module with 2 ribbon cables as micro controller (unreliable in 3%).
L14401 solder failures were caused by hot glue of very unique properties this one DID creep wide and far, down the leads of components, especially L14401 (subsonics vibration and thermals cycling plus glue creep broke the solder bond. Getting that glue out of the through hole is key for total success. Can't just resolder! Ditto to older chassis that had horizontal driver transformer that had RCA unique hot glue applied!
Fly failures were always the 32" and 36" of any rca chassis from CTC175 onwards.
CTC169 is a genuine, purely genius design. You have to study the theory of operation and schematics and get understanding of power supply and vertical circuit which is what a hoot (efficient!) and power supply control/feedback. I had good luck with them except for occasional bad CRT that shot the one transistor on the chassis.
PS: Those TV/VCR combos one thing you did bad thing instead of throwing out, should had tried to take apart that mode switch, polish with little heatsink paste (excellent polisher) and swab as polisher, once the silver-plated contacts are bright and free of tarnish, then clean up using swabs dipped in alcohol. Finally to prevent tarnishing use silicone grease on mode switch contacts. This fix will stop the shutting down problem after turn on.
Cheers, Wizard
Last edited by Wizard256; 02-24-2011 at 08:04 PM.
|