Quote:
Originally Posted by DaveWM
Not sure of the vintage of yours, but there are not a lot of paper caps in this one. The can caps are often fine. If the HOT is red plating the most likely cause is no grid drive since that is how it gets its neg bias. If you are just pulling the lead from the HOT and plugging it in to full line voltage, then the B+ will surely overshoot the voltage rating of the can caps, not good.
|
Hey thanks for the tips on this one! My 5111 is supposedly a 1964 model. I don't have a Variac, as well as a lot of other needed professional equipment. However, initially I used the 100W incandescent lamp method for at least a chance at a slow start. The reason that I disconnected the anode cap of the HOT was due to the smoking which started before any recognizable HV was produced. I knew that it would disable the circuit so I could see what might be going on in the rest of the circuits as far as overheating transformers, cans, smoke, etc. I had no idea that it could hurt my electrolytics. Seems like they would have engineered the voltage ratings higher if an open in that area could cause such damage. Luckily, I have never applied line current for more than a few minutes, and only a few times.
I'll tell ya, some of you guys blow my mind with your extensive knowledge of what is more or less a lost art. There is really no school that you can go to in order to learn what some of you guys know! Miniman82 made the following comment concerning video, "Stripping out the matrix and replacing it with something modern like component video is one, installing a modern IC-based video section having a comb filter is another." I was very impressed with someone knowing what it would take to improve or perfect antiquated circuit designs. I am an electronics student (at 41) in my final semester, and they just don't teach what I call REAL electronics! Thank God my dusty trail goes back to HS electronics back when we used Simpson analog meters and were taught at least rudimentary understanding of oscillators, detectors, etc. Now we learn the extreme basics of the full wave bridge rectifier using low voltages and current, controlling electromechanical relays, and lighting LEDs. I am scared to apply for a job based on that! Now we will possess the valuable knowledge of PLC programming and three phase applications. I guess that is their main focus to market us for employment.
I love bringing in old stuff and watching everyone but the asst. professor watch me work as if they were not even an electronics student. Even one of the few remaining Simpson meters will confuse everyone. I am just guessing that some of you guts have just been around long enough to have worked in electronics when it was truly electronics and less solid state, IC, riddled junk. Either way, I am glad to have contacts like all of you here and this great site. When I find a good job in the industry I plan on being an official member!