View Single Post
  #10  
Old 12-27-2010, 09:39 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by bob91343 View Post
The trick isn't adding solder. It's adding flux.
Adding eutectic solder that lowers the melting point does wonders for desoldering and soldering. Unlike non-eutectic solders, it has only one melt point. 60/40 has a W-I-D-E range of melt temps.

Yes, flux adds a catalyst that removes the oxides from the soldering operation (Lead oxide, tin oxide, cadium oxide, etc.) But for desoldering, flux does little.

Good ol' 63/37 has the lowest melting point (361 degrees F) of all Pb/Sn solders. It's the only alloy used in military electronic apps, for that reason and one other - it remains "plastic" for a far shorter period, reducing "cold" or brittle solder joints. The Navy's Micro-miniature repair school, AKA Soldering school, teaches that adding fresh solder to the joint to be desoldered helps in the removal of solder. We're not talking blobs, but adding 30% more solder or less to the solder to be removed. Works wonders, especially on circuit boards. Chassis? Likely no effect, or very little, due to the heat sinking of the chassis material. With chassis soldering operations, more heat/wattage helps most.

Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote
Audiokarma