View Single Post
  #7  
Old 11-25-2010, 07:30 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by ctc17 View Post
On the capacitors.

Hour usage has little if nothing to do with it. Davewm has a NOS Packard Bell he has the same issue with. I also have several NOS PBs with the lossy caps.

The only way to test this fault in the caps is an old school eye type tester. The eye wont open all the way with a lossy orange/red/brown drop.

It also appears to have allot to do with the circuit they are in. They drive the Vertical circuit nuts.

The symptoms are: poor deflection/linearity, one of the size controls at max, drift/size change with temperature/warmup, poor stability, having to adjust hold controls during warmup

It could just be the supplier rca and pb used in the late 60s. I dont remember running into this with Zenith or other sets.
Sprague made several types of "Orange Drop" capacitors:

PS Series - Film-Paper, and the most widely used by OEMs in TVs.

225P - Polyester Film/Foil
418P - Also a Polyester Film/Foil and widely used by OEM's in TVs.
715P/716P - Polypropylene (may be polyester in lower voltage ratings) - used in higher voltage/pulse apps, as in HV circuits.

SBE now makes all Orange drops, even those for Vishay/Sprague.

There are others (SBE has about 20 types of Orange Drops) but the above were the most widely used in the 50s/60s/70s. It's the PS series that give you headaches - the impregnant gets fully absorbed by the paper, leading to leakage. I've seen "NOS" 6PS-series Spragues with 5 megohms of leakage, and even had a few .0022uf/600V (6PS-D22) caps with flaky epoxy on the ends. 1970's vintage, never used, just went bad in the parts bin. My Sencore LC102 gets some mileage everytime I come across NOS film caps in my parts bin - new doesn't always mean "good". Worse yet, the OEM caps aren't marked to tell what series of orange drops you have.

I had a Setchell Carlson I recapped with NOS Sprague Orange Drops that gave me a fit with sync and AGC. I swapped some of them with CDE caps from Allied and fixed it.

I've never come across a bad "brown" Arco-Elmenco cap, ever. They made film/foil caps with the brown epoxy for Aerovox, GE, and themselves (EM on the cap). Maybe I'm just lucky. RCAs use a ton of these - my CTC16 is full of them, all good.

Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote