|
John - I did call them and they do not have them anymore... nice folks, but no older manuals.
CTC - thanks for the offer. I've used quite a few different CRT testers/rejuvinators and understand the basics. I wanted to test a 10BP4 and am using socket 1.
- I set the filament voltage (6.3) and bias to "C".
- Gun balance set to R/B&W
- I set the FIL SET to align with 6.3
- Run through H-K Shorts and G Shorts (no meter movement)
- Select GUN BAL and attempt to adjust to mark on meter - I get no movement of meter
- I select EMISSION and get almost no deflection - but can get movement if I changes the GUN BAL control
And general questions:
- What does Automatic tracking do in Tester mode?
- If the tube does not have shorts and is low on emissions, do I start with Auto Cycle in Restore or Rejuv first?
Thanks!
M
|