View Single Post
  #13  
Old 11-05-2010, 08:47 AM
Zenith26kc20's Avatar
Zenith26kc20 Zenith26kc20 is offline
VideoKarma Member
 
Join Date: Apr 2009
Location: New Orleans
Posts: 860
These are fun (?) sets to repair. Clean the transport mode location switch (WD-40 works) under the cam gear. Just moisten it and load and unload the tape a few times. Go thru all the functions.
If this doesn't fix them, remove the prism from the middle of the transport and using your cell phone camera, look directly down at the infrared LED. In the camera, you can see it light if it is good. No light, replace it with a LED from a dead remote. Be careful when putting the prism back. This will fix them 80% of the time.
If this doesn't get them going, get the garbage man to crush it and you can sometimes hear the CRT pop! The flat CRT marked "Magnavox" pop loud, as well as the Panasonic Tau's!
By the way, the cell phone camera trick is handy to test remotes too!
I'll take one of these over the Phillips TV's of about 5 years ago anyday!
Reply With Quote