View Single Post
  #10  
Old 10-14-2010, 06:30 PM
Eric H's Avatar
Eric H Eric H is offline
Administrator
 
Join Date: Jun 2002
Location: So. Calif
Posts: 11,565
I've replaced all but six of the old caps now, there are about 31 paper caps in this chassis, which is about 25 fewer than the Philco 48-2500 I just finished recapping.

Three of the caps on the Flyback were .001@6000v
those were used in the doubler circuit, I had those in stock because I've been ordering a few HV caps each time I send an order to Justradios.

One of the sand resistors had been jumped already and another one died while I was testing the set, the last one will need replaced soon too since it has the green corrosion on the leads that these all seem to suffer from.

I've ordered the eight electrolytics I need to restuff the cans, I also ordered a new 6AU5 for the horiz output, this one tests OK but the getter is mostly white with only a sliver of black left!

Even with most of the Electros jumped I still had low HV, about 2k was getting to the CRT and I could see a faint line when the set was switched off.

I think a poor 6AU5 combined with the load on the B+ caused by the leaky Electros is keeping it down.

While I'm waiting for the caps to arrive I'll spend some time cleaning the chassis and fixing the cabinet.
Attached Images
File Type: jpg oldcaps.jpg (25.3 KB, 23 views)
File Type: jpg recapped.jpg (63.0 KB, 36 views)
Reply With Quote
Audiokarma