View Single Post
  #4  
Old 09-28-2010, 09:40 PM
RitchieMars's Avatar
RitchieMars RitchieMars is offline
VK Member
 
Join Date: Apr 2010
Location: Fountain Inn, South Carolina
Posts: 244
I had the same problem with my Zenith. The plastic had deteriorated and made an ungodly mess. Probably not the best choice of materials, but I'm pretty good with card-stock and a pair of scissors so I formed a cover from that and assembled it with a mess of electrical tape. The neck doesn't seem to get all that hot around the yoke, not as much as it does near the filament. It has held up fine so far, but I'd like to improve on it by coating it in something firm and heat-resistant and seal it up with some kind of glue instead of the tape holding it together. I just needed something to support my centering rings, and I hope to later improve on this design with better materials.

Reply With Quote