|
Just an update....
For the last couple of weeks, the set has run much better. It only shut down that one time, so I was just going to let it be. Well, on Friday, Laura told me it wouldn't "turn on at all". Symptoms: It would power up audio, but no relay click, and then shutoff.
I had left the back off of the set, as I had meant to pull the board and redo the solder connections as had been suggested here. The main board is divided down the middle: power supply/sweep on one half, logic and tuner on the other. I touched up all the connections on the power side, and found some dodgy soldering connections in quit a few places. But, I think I found what was causing the problem: On the flyback, one of the pins looked like it had no solder at all! If the flyback was a tube, I would call it pin #1. There were some very small traces of arcing around that pin as well. Needless to say, I rectified that in a hurry, and the tv is back and running. There are a few more caps I'd like to replace, so I'm leaving the back off for the time being.
|