|
I remember working on one Magnavox, circa '74-'75 19" set that had an inline tube with a bonded yoke. I don't remember the chassis number; but, it was the chassis that was around just before the vertical T991 19" chassis came along. The T991 was one of the ones that used a 4 lead safety cap that was very prone to shorting and this set also used a bonded yoke CRT.
I've seen some other cheap imported sets of the '70's and '80's that had a label on the CRT that warned that the yoke and convergence assembly was bonded to the CRT and warned the servicer not to attempt removal. However, on these very sets, I have loosened the clamps and the yoke and convergence assembly came off as easy as any other non bonded yoke.
Bonded yoke tubes are nice in the fact that one does not have to fool with purity and convergence; but, they are not so nice if the yoke becomes defective and the whole CRT has to be replaced.
|