update on the vert jitters, replaced C168 (.1 1kv) off the plate of the vert mult (6BA11). It tested fine for value but leaked badly at 450v (as high as my cap tester would go). I did not have a 1kv handy so I put two .22 630v in series. I will order up some .1 1kv next time I order from mouser. There was another .1 1Kv that is part of the horz eff coil circuit. it tested fine at 450v no leakage at all, but it will get replaced when I get those new ones. Not sure if its ok at the higher voltage.
I took the chassis out after struggling with one of the plastic connectors (what a pita). Anyway it was major league dirty, I mean disgusting, so I used the makeup brush (ask a girl), some compressed air in a can, and cleaned the underside. the top side got the same treatment and some slick stuff cleaner to get the goo off the chassis. Cleaned up the fly cage and anode lead, and the crt around the anode.
while I had the chassis out I checked some resistors, replaced one a emitter bias resistor that was a 10% that had drifted to about 30%. its on the only transistor in the set a video amp. I dont get why the bother to get a single transistor in the whole set.
I checked a couple of the screen bypass electro caps, all tested fine, good as new. amazing. I figured better to leave them in as I wonder if the new caps will last as long.
there was a .1 in the video path that couples the transistor video amp the video out tube. the audiophoole in me makes me want to go a change that out for a designer cap
while I had it out I check the crt, I had rejuved it on the red gun back when I got it, but I checked it again and it was a bit into the weak on my CR 70.
the tracking on the blue and green were very good the red dropped way down.
its gonna need a new 23v (I have one) but I just did not feel like taking the old until I put the chassis back in and made sure I did not goof anything.
I need to do a horz eff setting check. I never did that with this one, as the coil is in a place that is very hard to get out, but I just realized i can get at it from the bottom thru the service saver cover, duh...
oh there was one other out of spec resistor the cathode resistor on the vert multi. R115 should be 3300 was 4400.
I could not make out the tolerance it "may" have been a gold banded, but its hard to tell, the schematic does not say so I figured it was prob a 20% so it was not that far out. The vert circuit is working fine now so I decided to leave it alone.
the picture is really not that bad so I may just leave it for a while. it has a
25GP22A tube in it.