View Single Post
  #28  
Old 07-14-2010, 12:19 AM
jeyurkon's Avatar
jeyurkon jeyurkon is offline
VideoKarma Member
 
Join Date: Oct 2008
Location: Central Michigan
Posts: 1,699
I don't have a schematic for your set, but if it's like the 6T72 then it could be anything from the 3rd video IF on. I don't think it would be an AGC issue.

But, maybe it's something really simple. It looks like you could still have a raster and no effect from the contrast control if the CRT socket was making a bad connection to G1 of the CRT. That would be the video output line. I'd check for that. It could even be a problem with that pin of the CRT needing re-soldered.

Since you had a broken pin in the the socket of the video output tube, 12AU7, then there's a chance that the socket was damaged, perhaps that socket was spread wide and isn't making good contact now.

Try measuring the DC level of the video output going to the CRT. On the wire going to the CRT it should be a negative value. On the 6T72 it appears it would be -1.8VDC.

John
Reply With Quote