Thread: Zenith console
View Single Post
  #52  
Old 06-23-2010, 05:14 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
I think I get the pincushion circuit.

looks like a horz pulse it applied to both the grid and the plate of the tube, the tube bias is controled by cathode bias which comes off the vert out transoformer.

So since pincushion correction along the top needs to have the vert deflection oppisite directions when on top and on bottom, the correction is derived by having the tube cut off (due to bias) and only the plate input of the horz being the driving force of the vertical adj (a cap smooths the horz pulses and applies to the vert yoke thru the pincussion adjustable transformer which is tunable I presume to the hors freq.

when the tube is NOT cut off by the cathode pulse then in conducts from the grid input of the horz freq, this gets inverted in the tube and nulls out the pulse at the plate, this is the waist I see on the scope.

Since the waist is not thin enough (i think) I have to presume either too much plate pulse is coming thru the cap that goes to the boost, or the tube is not conducting enough to null it out.

The grid of the tube is fed by a 220pf cap that goes to the same boost souce so it could be that it has developed some kind of interanl resistance (I doubt this since its a disk, OR the plate feed cap from the boost is perhaps leaking or drifted up in value (not sure about all this). Its a white ceramic tube .0012 1kv cap, so its prob a paper inside.

I recall my pulse at the plate was much larger than it should have been (which would explain the inablility of the tubes inverted pulse being able to null it out.

I am kind of suprized that zentih to not provide for an amplitude adjustment to the pincushion adj. the adjustable transformer just seem to tilt the correction more that increase/decrease the amplitude of the correction to the yoke.
Reply With Quote