|
well I have been watching it some more and still not satisfied with the pincushion correction. I put a scope on it and examined the output of the waveform from the plate of the pincushion tube, I noticed a a lack of a waist in the form. It had some just not what is showed on the sams. The P-P value was was off also, not sure what that is all about.
there is a resistor/cap network in the grid of the pincushion tube. I tried increasing the cap value, and the waist got wider not smaller. So my next check will be to take the cap out of circuit and check it.
There is also a 100mfd electro that comes of the cathode of the vertical output tube, it looks like that is the source of the vertical componet of the wave since it looks to bias the tube at the cathode. Its a little over my head what it is doing but I will start there.
|