Thread: Zenith console
View Single Post
  #50  
Old 06-22-2010, 07:34 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
pulled the tuner, it did not seem too dirty, but I did some brown off the fingers and the tuner strip buttons.

Next up was to free up the UHF. 1st I separated the tuner from the picture and volume control panel. Next up I removed the outer plate that allowed access to the stuck main UHF gear that drives the channel indicator. Removed the large circlip, worked off the stuck gear, sanded the inside with a socket wrench and sand paper to make a drum sander that would fit. worked it by hand, testing the fit as I went. when is seems free enough (turns easy but no slop) I put a bit of tuner lube on it ( I guess its safe on plastic and will not gum up) put it all back and reset the UHF indicator. replaced all the circlips, buttoned it all back up. Cleaned the tuner tube pins while it was out. The only casualty was the color knob, it cracked coming off. Some super glue and strong sewing thread wrapped around it and glued pulled the crack up tight.

used some pot cleaner lube on the VC and the pesky afc switch while it was out. Popped out a few strips on the tuner get get access to the fingers, channels 6-10, I never remove 3 or 4 just in case I were to break one.

the result, perfect tuning, not more snow etc.. no more critical setting. The UHF still seems a bit tight, but its not the gear. I did lube the UHF tuner shaft, maybe it will loosen up with use. It works fine just seems a bit tight. The fine tune on the UHF work as it should. I was able to get some OTA analog using it.

The UHF fine tuning is working again as is the AFC switch, and best of all the audio is perfect now, no more jiggling and fiddling to get it right, and volume is up across the board.

I will button it up later and get some screen shots. Over all the tuner was not a big deal at all.
Reply With Quote
Audiokarma