Thread: 1-125 Sylvania
View Single Post
  #2  
Old 06-21-2010, 10:57 PM
jeyurkon's Avatar
jeyurkon jeyurkon is offline
VideoKarma Member
 
Join Date: Oct 2008
Location: Central Michigan
Posts: 1,699
12VP4 test

I installed the 12VP4 in the 1-108 Chassis I have working. At first I thought the CRT was completely dead, but after turning the brightness up to maximum I was able to get a raster playing with the ion-trap magnet.

I let it play for awhile. The video shot looks better than it is because of the camera. It's barely visible in dim room light.

The scan line splits into two lines as it crosses the center. It should just get wide. I need to move the focus magnet forward. I think the apparent split is because the center of the cathode is pretty used up.

There is a pin point burn right in the center of the CRT where someone must have had HV, but no horizontal or vertical sweep. Or else it's just a defect.

I could try baking the cathode at a higher voltage. Rejuvenating it with any other method is out. I don't think even the Beltron knows about this tube.

So, do I send it to Scotty or modify the set to use a 12LP4 and keep this CRT as a collectible?

John
Attached Images
File Type: jpg 12VP4_VID.jpg (77.4 KB, 39 views)
File Type: jpg 12VP4_DOT.jpg (114.2 KB, 37 views)
File Type: jpg 12VP4_TEST.jpg (83.2 KB, 51 views)
Reply With Quote