Thread: Zenith console
View Single Post
  #45  
Old 06-21-2010, 08:14 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
oh and the vertical and flicker seems to have resolved, I guess just running if for a while may have driven out moisture or pehaps reformed a cap somewhere.

There was a slight ringing in the pix (right side brightish outline) that I got rid of by going thru the IF tubes. I was checking and subbing until I got to the 3rd IF which tested with shorts. I confirmed that the new tube did not have shorts and I tested the bad on two different testers (hickok 533 and a dyna quick). Replacing that tube did the trick no more ringing.

The other tubes tested just in the ok range, but a sub did not seem to improved the pic so I put the orig back in.


I assume the short was causing some oscillations in the IF circuit.

I should have check the signal with my scope, I would have liked to have seen what a ringing signal looked like. I would have put on a test pattern and then started at the grid of the 1st IF tube. I already chucked out that tube so too late to try it now.
Reply With Quote
Audiokarma