Thread: Zenith console
View Single Post
  #40  
Old 06-12-2010, 08:35 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
just read in the service manual from zenith that jittering vert could be due to a faulty service switch (the one I tried cycling several times) said something about making an "air connections" I assume they mean to just jumper it, also said meter may not see the resistance, therefore the recommedation to "air connect".

there was also talk about a diode/resistor combo to increase convergence range that I may look into (the right side is still just a bit out).

Lastly I think I will check on the cap that is connected to the pincussion coil. No mention of a problem but since its a tuned circuit I was thinking that maybe a out of spec cap may account for the lack of adjustment range, although its more like a lack of amplitude than freq since I can see the center widen to a point but then it starts to shrink back before its completly flat.

I am going to study that pin cushion circuit a few more times to see if I can get my head wrapped around it.
Reply With Quote
Audiokarma