Quote:
Originally Posted by DaveWM
take a heat gun to it and gently warm up caps. I did this on a 2007 phillips SPC tv, the heat lowered the ESR enough for the set to turn on, it was a small 5uf cap in a regulator circuit. I was able to isolate the cap by heating different part of the main board until I found the problem area. Of course an ESR meter would have been less crude, but I dont have one, yet.
|
Would a hair dryer do? I'll have to give that a shot too.
__________________
Mom (1938 - 2013) - RIP, I miss you
Spunky, (1999 - 2016) - RIP, pretty girl!
Rascal, (2007 - 2021) RIP, miss you very much
|