Thread: Zenith console
View Single Post
  #4  
Old 05-31-2010, 07:47 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
That was painless, just snipped out the old diode pack (all were open) left the little bits in but for the ground which i heated up the little solder pot, and pulled out the remnants as I would be having 4 diode ends going in that common ground. I put spagatti on the diodes (color coded) and installed.

Whats nice is now that I have a good diode pack (well after I test it anyway) is I have a set of reading that I can use in circuit to compare other convergence boards with. It will not be fool proof, but hope it finds open or shorted diodes in circuit.

I am getting tired and its dark in the shop as my lighting is not the best so I think I will just bag it for now and reinstall tomorrow. I hope my convergence woes are over.

With out having a lot of experience the problem is knowing when a convergence board is working right, marginal, very weakly.
Reply With Quote