Thread: CTC-21 combo
View Single Post
  #8  
Old 05-17-2010, 01:15 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
found something interesting that may have been a cause of the vert. Granted I was not able to check the voltage at the plate of the vert out, but I did trace the primary windings back to its source of B+. There is a big 600 ohm resistor looks like at least 18 watt right off the hot side of the choke (420vdc). this resistor is what drops the 420 down to the 370vdc for the vert plate load thru the primary. Well the wire from the choke to the resistor was nice and green and toasty, and did not even seem to be well soldered (I was able to pull it thru. I am guessing there was a voltage drop right there. I replaced the wire, cleaned up the term strip fluxed and soldered it back. Maybe I will get lucky on this one.

Look for the broken wire before anything else....
Reply With Quote