View Single Post
  #12  
Old 05-09-2010, 01:48 PM
kx250rider's Avatar
kx250rider kx250rider is offline
REAL TVs have TUBES!
 
Join Date: Oct 2005
Location: Los Angeles & Dallas
Posts: 3,239
My method on those, was to set the G1s at midrange, turn all 3 G2s to min, color to min, and Chromatic switch off. Service switch on, and try all 3 G2s. If one doesn't show up, or if one is already there with G2 at min, turn down CRT Bias/bright limiter (on the socket board if yours is a 9-121, or on the chassis if it's a conventional socket on the tube) until it's out (or up until weakest one can be turned up with G2). Turn the 3 G2s to a very dim white line, then turn the service sw to Normal. Turn the picture (cont) to min, and brightness to max (or a bright, washed out picture). Set G2s slightly for best gray, then turn up the picture and set G1s for best whites. Repeat 2 or 3 times if the set is being Irish.

This is slightly off from the book procedure, but I like it better on those bright Zenith tubes.

***BEWARE: Those G2 pots are VERY FAMOUS for being burnt. If you get one that doesn't turn nicely up & down (acts like an "ON-OFF" switch in stead of a control), you need to replace the pot.

Charles
__________________
Collecting & restoring TVs in Los Angeles since age 10

Last edited by kx250rider; 05-09-2010 at 01:51 PM.
Reply With Quote