|
Sometimes, with either all the screens down or the drives you can still have a gun that appears to be a little "hotter". Since you adjust the screens first you can disable the drives (sometimes easily) to get the screens most uniform then connect up the drives and only bring up the others to the point of intensity of the "hot" gun, and adjust up from there.
It is good to have the brightness control centered for starters, but if the range isn't there then you can always go up on the Kine Bias switch/pot too, or after your initial settings if tracking is poor or brightness is still low.
After all of this, if retrace lines are appearing then turn the Bias down.
If you have all the screens down and you see a hot gun other than red, you can load down the screen with a 100K resistor so you can set purity. The old school TV guys would rig up a box with 100K's in the and a toggle switch for switching off the guns. Some old troubleshooting books will go through this too.
If the tube is good and tracking well, you should be able to go through the range of brightness and maintain it gray scale.
If you don't like the results you can always repeat. If the tube has been rejuvinated or has a new gun, it may settle in a bit and you're re-adjusting again!
Then there's always that "It don't look right" and an hour later your still fussing over it!!
It's been awhile since I've gone through the process but you know the drill..!!
|