Thread: zentih Avanti
View Single Post
  #5  
Old 04-28-2010, 10:20 AM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
I willl get some pics later with the service panel pulled. I did not see any white caps under the chassis around the fly, I did see some big Disk caps.

there were also a few MONSTER looking .47 600v caps that I presume were not paper. they were configured like a orange drop but IIRC were brown and had a dull finish on them.

the nichicons under the chassis were 10uf 300v axials.

I was thinking of replacing them with some axial 450v caps.

On these zenith chassis with the solder pegs, I assume you just heat the peg on the top and keep pulling on the part until it pulls out.
Reply With Quote
Audiokarma