View Single Post
  #8  
Old 04-13-2010, 06:00 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by Jeffhs View Post
Without a manual channel selector knob anywhere on the set, how did one change channels if the remote got lost, broken, the motor drive went bad, or the remote's batteries went dead? Seems like a very poor way to design a TV power tuning system; after all, most TVs with power tuning and remote had a manual channel selector on the back of the set, to be used in case anything went wrong with the drive system or the remote hand unit itself.
The front of the set has the requisite controls - channel and volume up/down, which also control the power. See the second photo above.

If the motor drive went bad, neither remote or front controls would do much good. It's a varactor design, so manual means are exactly what RCA was "designing out" of the set. It's the precursor of todays sets with no manual means other than tactile buttons on the set and remote.


Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote