View Single Post
  #150  
Old 03-11-2010, 07:23 AM
Reece's Avatar
Reece Reece is offline
VideoKarma Member
 
Join Date: Jul 2004
Location: Cleona, PA
Posts: 2,178
Sounds like something has drifted in the first I.F. Easiest would be to parallel a small mica cap, maybe 10 to 20 pf? across that trimmer C19. Just tack one in to test. This would increase the total capacity. Since the capacity would now be too much, it should allow you to back the screw off to lower the capacity to find the peak.

Rough sound: is the speaker voice coil rubbing on the pole piece? Sometimes this is only apparent with higher volume. With the set off, with fingers of both hands carefully move the cone back and forth to check for rubbing. Jump a PM (permanent magnet) speaker across the voice coil terminals of the original speaker to see if there's a difference in sound.

Do you still have excess hum? You could set the speaker over a hole cut in a cardboard box for a baffle to hear the hum better. If there is hum, does it follow the volume control setting? If the control works smoothly with no jumps, don't think the control is the problem.
__________________
Reece

Perfection is hard to reach with a screwdriver.
Reply With Quote
Audiokarma