View Single Post
  #11  
Old 03-10-2010, 01:08 PM
de.facto7's Avatar
de.facto7 de.facto7 is offline
AK Subscriber
 
Join Date: Feb 2010
Location: utah
Posts: 112
almost there

I'm almost there, Guys. I just found an old antique collector in town with
some old tubes. One of them was a 6J7 G so I though why not. I gave him a dollar and took it to a place with a tester. It tested as high as it can get. I stuck it in and the hum is down to practically nil. The volume is not quite as high but at least there's no hum on stations and practically none in between. Most of the reception issues now are just antenna related.

I would like to send out a huge thank you to all those who have guided me through this adventurous procedure. I have a lot of computer and mother board experience... but in computers, all the real important stuff is already laid out and you just have to know your passives and hardware. Working on this antique radio has sure showed me how much I don't know about what is at work in electronics. I would bet that more than 75% of computer "experts" are just "package" experts, E.G. tear open the plastic bag, stick the part in the little holes in the traces and solder it in. Even when you are working with PCB, you lay it all out before hand and the traces are perfect (hopefully), then you don't think about that anymore and stick in the parts. Big deal. But with radio.... the wires, the connections, the modifications, the common sense, the rudimentary circuitry, 3 dimensional space instead of 2... It makes one think in a whole different way, a more thorough way.

I think the only thing left to do is to try adjusting the SW side. Is there a general procedure that can get me pretty close. I don't have a scope or anything but reading the manual there are tools mentioned that I'm not sure I understand how to use or make like the metal filing thing or the ring. It would be really interesting to try to tune this up the old way, the way it was done back in the 30's.

Guidance offered would be greatly appreciated!

Thanks again,

Martin
__________________
--> Tell the truth and run. - Yugoslavian proverb
Reply With Quote