View Single Post
  #129  
Old 03-07-2010, 12:54 PM
Reece's Avatar
Reece Reece is offline
VideoKarma Member
 
Join Date: Jul 2004
Location: Cleona, PA
Posts: 2,178
That's great! It means your local oscillator is working so that it can mix with the received signal to produce the I.F. frequency. I wasn't sure before if you were just receiving an RF signal blasting through or if the superhetrodyne circuits were working.

What I like to do is make a copy of the schematic and then go over the chassis wire by wire and mark them off one by one on the schematic with a highlighter as I go. Concentrate now on the circuits around the 6A8 and the 6K7. Something keeping the signal from getting strongly through the IF section? You mention a 50K resistor inside an IF can: I don't see it; can you I.D. it on the schematic? Does it look factory? Sometimes resistors are used to lessen selectivity but ...?

Do the easy stuff first! Clean the cap!
__________________
Reece

Perfection is hard to reach with a screwdriver.

Last edited by Reece; 03-07-2010 at 12:56 PM. Reason: Clean the cap.
Reply With Quote