|
From the schematic here is what you should have on the 6A8 and 6K7:
6A8
Pin 1 0V
Pin 2 to Pin 7 6.3VAC
Pin 3 262VDC
Pin 4 102VDC
Pin 5 Not shown but should be negative DC
Pin 6 190VDC
Pin 8 4.3VDC
6K7
Pin 1 0V
Pin 2 to Pin 7 6.3VAC
Pin 3 251VDC
Pin 4 102VDC
Pin 5 3.4VDC
Pin 6 not used
Pin 8 3.4VDC
Pretty close to what Leadlike came up with. The voltages you got on pin 3 of the 6K7 and 6A8 are somewhat in line with what you should get. The voltages on pin 8 of both tubes are good. What you show on pin 6 of the 6A8 in post #107 is way low. Measure the voltage you have on capacitor C13 (junction of C13 and 40,000ohm R3). If this voltage is really low then either there is a short around there or R3 is open. If this voltage is high (around 390V) then you probably have an open winding on the oscillator coil L5 and/or L7.
__________________
Sean - WØKPX
|