|
For me... it's as fun as it gets. Many call me boring though.
I'm going to come back to your speaker discussion in a moment but I have been doing some snooping. I have tried to follow as many circuit connections as possible and following the schematic as much as I can decipher it. I started backward from the speaker connection (3 of them to the radio) following the path through the caps, power, switch eventually terminating my adventure at the 6f6 and the 5y3. everything was connected correctly, polarity on caps correct, I even checked all the solder joints and did a continuity check on all the connections therewith. I can't see anything wrong. So, I plugged it all back together and raised my light bulb to 75W. As it should, the bulb went up while things charged and then backed down again though not as much as I would expect. The tubes started to glow and after about 30 or so seconds, I heard a little noise in the speaker. Not much. Well, WTH... I put in a 150W bulb and the same thing but the tubes were brighter. The bulb started up slow and stayed there then went up to about 20% at which point I heard more noise in the speaker. Not a loud hum or a lot of static or Inagodadavida or anything, just that radio noise when there is no station and your between bands of something. So, I said... let's burn the house down! I plugged into the house current.... and the house didn't burn down.. neither did the radio. It just warmed up for a few seconds, the tubes were nice and bright and the speaker was the same as before. 'no noticeable electrical odor, no exploding caps. Upon adjusting the tuner, I got nothing, but then I don't have an antenna wire hooked up either. I figure, when it's time to think about tuning I'll think about an antenna.
OK... what have I got guys?
Speakers... There are 3 wires from the radio to 3 of 5 pins at the plug. The plug on the speaker side interestingly is connected directly to the voice coil! Hmm, never saw that before. There is a transformer of sorts that is screwed right to the back side of the speaker frame. That's the one I was talking about. The main speaker coil is not in question.. yet. BTW, I just built a set of 8 Ohm speakers for my stereo amp with homemade 2 way crossovers made on a PCB that I drew then etched with peroxide and toilet bowl cleaner. They are working really well.
But, I still don't know much about antique radio, that's for sure!
__________________
--> Tell the truth and run. - Yugoslavian proverb
|