View Single Post
  #11  
Old 03-04-2010, 06:47 PM
de.facto7's Avatar
de.facto7 de.facto7 is offline
AK Subscriber
 
Join Date: Feb 2010
Location: utah
Posts: 112
Well, that was interesting but no cupie doll. I have 4V on pin 2 to ground now on the 5y3 w/o tube and 6f6 with tube. With both those tubes in and the speaker plugged in, I still show a short on the bulb tester but not as sharp as before; it's still too high though. Without tubes, all the main voltages have reasonable readings as before. I still show no voltage on the + side of the 10uF 500V cap (which in now neg. to chassis).

Heeelllp! I'm not sure what to check next.

If my schematic was clearer, I think it would help. Are there other sources for those manuals? This is just such low res that even panning in, the words and numbers are a complete blur. Since I don't know enough about electronics, it's all guessing for me trying to figure it out.

You guys have been great and very patient. Thanks.
Reply With Quote