View Single Post
  #66  
Old 03-02-2010, 07:46 PM
leadlike's Avatar
leadlike leadlike is offline
VideoKarma Member
 
Join Date: Apr 2008
Location: Lancaster, Pa
Posts: 956
The rectifier filaments may read high until you have a current draw going. The power supply for my GE 802 was the same-I was getting 8 volts at idle on the filament string, and then back to 5v when it was running the set.

Tell us the plate voltage of say, pin 3 on the 6f6. It should be at least a couple hundred volts. Tell us if you have any voltage on c14 (your 10 mfd electrolytic capacitor) on the positive end of the cap versus the chassis. If you are getting voltage at that lytic but not at the 6f6, then you may have a problem with the field coil in your speaker.
Reply With Quote