View Single Post
  #9  
Old 02-26-2010, 10:32 AM
kx250rider's Avatar
kx250rider kx250rider is offline
REAL TVs have TUBES!
 
Join Date: Oct 2005
Location: Los Angeles & Dallas
Posts: 3,239
Good news! I powered it up cold turkey, just hoping that it would be OK, and it is! No problems, and the CRT is the best I've seen since the last time I put a new one in a customer's set!!! Amazingly, the tuner contacts and volume pot aren't even dirty! I guess the original lube is still intact. Perfect gray scale, perfect convergence, and all!!! So since the Sony badge had fallen off and got lost, I poked around and found one, and now the set is 100% flawless. I probably won't keep it here in Moorpark, as we do get a salty, damp ocean breeze in the afternoon and metals tend to get dull here. That metal framework in the chassis just gleams, as do the plastichrome knobs. I've seen these sets where that is all dull and powdery, and that won't be allowed on this set.

Quote:
Originally Posted by DaveWM View Post
do you have to worry about low voltage causing no osc on the horz? during a variac power up that is? I have been told (and do) to pull the horz out tube when doing a slow startup.
I don't think so on this power supply. The oscillator starts up suddenly at about 75 volts, but at full 15.75. The tube sets' horizontal oscillators can start up slowly, and hotplate the output. I used to use a Variac to start Sonys after replacing the horizontal output SCR, and to test the oscillator, I'd run that on a 9-volt battery and scope it at the collector of the horizontal driver first, before trying to start the TV. There was an electrolytic cap that would sometimes go bad, and flatten the oscillator; causing the new output to blow after a couple minutes if it wasn't checked out thoroughly.

Charles
__________________
Collecting & restoring TVs in Los Angeles since age 10

Last edited by kx250rider; 02-26-2010 at 10:37 AM.
Reply With Quote