|
OK...
Your first and second paragraph tests out OK.
If I am counting the pins correctly on the 5Z4 (the schematic is illegible and marked with letters P1 P2 H S can't read the others) then I am getting between .5 and .6 ohms between pins 2 and 8.
On the 6F6, I get between .3 and .4 ohms between 2 and 7 (again if I am getting the pins right). Both pins are grounded to chassis as a matter of fact only pin #5 and #6 are not grounding to the chassis.
The dial light is clipped and pin #6 is disconnected on 5Z4
__________________
--> Tell the truth and run. - Yugoslavian proverb
|