View Single Post
  #11  
Old 02-25-2010, 11:58 AM
de.facto7's Avatar
de.facto7 de.facto7 is offline
AK Subscriber
 
Join Date: Feb 2010
Location: utah
Posts: 112
Hey guys... I'm back.

I have a problem. I've been pretty lucky in the past with computers and stereo rebuilding considering I am highly inexperienced in electronics. I've recapped many a mother board with success etc, but this!... this advanced tube technology... it's over my head I'm afraid. I am very willing and ready to learn though.

The A-66 is completely recapped. I replaced most of the resistors. I replaced all the wiring that was necessary which was 95% of it. I have stayed away from the coils except to replace absolutely necessary main wires so as to do as little disturbance to them as possible; I only replaced those wires by continuing from the old wiring about an inch off the coil's solder points. I have done the best I can to replicate the capacitors and resistors according to the specifications of the removed part.

With all tubes removed, I plugged into my PMV w/ a 60W bulb. It shows a short; there's no drop in the bulb brightness. Both power plug leads show no continuity with the chassis. With power on, I get 3.4V AC on the chassis.

Like I said before, I've been pretty lucky in the past but I guess here's my chance to learn some troubleshooting electronics. If anyone is willing to help, I would surely appreciate it.

Thanks!
__________________
--> Tell the truth and run. - Yugoslavian proverb
Reply With Quote