Thread: My 1st Predicta
View Single Post
  #20  
Old 02-13-2010, 08:43 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
found it, the vert tube socket had a micro fracture at the pin socket, I tested ok for resistance since I would touch the prob to the pin socket, which in turn pushed it down and closed the fracture. With the tube installed the push was gone and the fracture would open up.

I found it by using my tube test socket, and cliipping on to the test point rather than pushing it with the prob, bingo it opens right up.

I think I have a pcb mount 9 pin mini AND this is an easy to get at one, so I plan to just remove the socket. I tried to bridge over the fractrue, I may try that again I just have to get a small file in there to clean the metal so the solder will stick. the damper seems ok for now.

I am not sure if its a socket or pcb issue with the damper, I will play with it some more, but like Charlie says I may just move it to the sweet spot and be done with it.

I need to check the HOT current next to see how that is doing.

I have a buddy that does vacuum forming I may get him to mold up a new cover for the CRT, mine is ok but I would like a crystal clear one it I get this working right.
Reply With Quote
Audiokarma