|
Ok, here is the deal, the resistor was ok (I was reading the wrong pad, again due to the upward mount of the resistor), but I got it fixed!
Very odd, It seemed like the signal was working upto a resistor, no signal on the side that comes from the pot, but signal on the side that goes to the amp, odd. I disconnect the jumper wire that connect the amp to the output of the loudness pot. no signal now (I have the pot turn all the way down, and signal was still getting amplified). hmmm I check the amp side no signal there either, hmmmm. I resolder the jumper and bingo its working fine now.
I have no idea what was going on, why the amp was getting signal with the loudness turned all the way down, but its ok now (I think, I am going to hook up and try again. very odd).
|