View Single Post
  #97  
Old 02-03-2010, 06:20 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
found a 33k resistor in the bass tone circuit that had drifted off to over 100k and since the bad side has no attenuation in the tone circuits i will start there.

I am feeding a audio sine wave into the tape input and then tracing with the scope comparing L and R (they are both getting audio feed thru two coupling caps to the same source). I could see a change in amplitude at one point which then I checked with the meter to find the bad resistor. Its kind of a pain since its a pcb with resistor up on end, so you have to measusre from the foil side and look at the top side to see the color bands.

hope this is it...
Reply With Quote