Quote:
Originally Posted by 7"estatdef
So is it common to smoke the width coil when the 6W4 goes? Or should I take a look for other problems?
Terry
|
It is common for the width coil to fail when the trouble you have described occurs. When the cathode of the tube is at ground potential (as would be the case with an arcing filament winding) very heavy current is drawn through the coil. It is this pulse voltage that causes the tube to break down from heater to cathode.
If you use a 6AX4 or 6AU4, you may find that you can actually go back to the original filament winding. Since the high pulse voltage won't be present on the later tube type's filaments, no arcing will occur.
To Matt...
You are correct about the B+ connection to the 6W4 filament in your set. It was to limit the pulse voltage. However, I would strongly recommend replacing your damper tube too with one of the later ones suggested. Those tubes were developed for exactly this reason, and will save lots of heartache down the road.
Others that will work and give you the same measure of protection:
6DA4
6DE4
Always do yourself a favor... tap the damper tube when the set is on. If it arcs, change it. It's gonna short.
BTW guys...
Those tubes are SOOOOOO common you should be able to find as many as you want for a buck apiece.
Good luck!